Advanced Manual

Adding a Demo Video

Demo Mode

The Demo Mode allows a dealer to add a Demo Video to

the panel.

To add a Demo Video:

1. Navigate to the Installer Toolbox and tap Demo

Mode.

Installer Toolbox - Demo Mode

2. Copy an mp4 video onto a USB drive.

Notes:

File size - cannot exceed 200mb

Recommended Resolution - 720p/30 frames

per second, not to exceed 20Mbps

3. Insert the USB drive into the top of the panel.

4. Press the Replace Video button.

Demo Mode - Replace Video

Verify the Radio Status

After installing the Cellular Radio Module for the ﬁ rst time,

perform a radio test to check the cell signal strength,

conﬁ rm the serial number of the module, and view other

information about the cellular radio connection. This is a

helpful tool to use when troubleshooting the installation.

To open the Radio Test menu, navigate to the Installer

Toolbox. Then tap Radio Test. At the Radio Status

screen, tap Start Radio Test.

When the test is complete:

A “Success” message indicates the module is

functioning properly (see next image).

A “Cell Radio Module Status Not Detected” message

indicates a module is not properly installed. See

“Install/Replace the Cellular Radio Module.”

A “Remote Services Provider is Not Set” message

indicates that the installer has not programmed a

Remote Services Provider for the GC3 Panel. See

“Q7: Remote services provider.”

Installer Toolbox—Radio Status Test Success