Tech Drawing

8
Copyright © 2019 Nortek Security & Control LLC
Arm the System (Away Mode)
Apply this mode when people and pets will be leaving the premises. Typically, the installer confi gures the system so this mode arms both the perimeter zones (for
example, doors and windows) and the interior zones (for example, motion detectors).
To arm the system:
1
Tap Arm Away.
2
Exit the premises before the audible Exit
Delay countdown expires. During the
countdown, you can tap Silence which
will extend the length of the timer and
silence the audible countdown.
3
After the Exit Delay expires, the
system announces, “System Armed
Away.”
NOTE: Consult your installer to determine if the Auto Stay feature is enabled. For compliance with ANSI/SIA CP-01-2010, when Auto
Stay is enabled and you arm the system in Away Mode, you must exit the premises through an Exit/Entry door. If no one exits out
through an Exit/Entry door by the end of the Exit Delay countdown, the system automatically arms itself in Stay Mode. For more in-depth
information, see the GC3 User Guide.
NOTE: Consult your installer to determine if the Exit Delay Restart feature is enabled. When this feature is enabled, if you exit and then
re-enter the premises before the Exit Delay countdown expires, the Exit Delay countdown restarts one time before the system arms. For
compliance with ANSI/SIA CP-01-2010, this feature is enabled by default. For more in-depth information, see the GC3 User Guide.