User Manual

Copyright © 2019 Nortek Security & Control LLC.
27
2. Enter the Duress Code.
Enter the Duress Code
The system disarms and transmits a silent duress report to
the Remote Service Provider.
Transmitting a Duress Signal when the System is
Disarmed
To transmit a user duress report when the system is
disarmed:
1. At the Home screen or from one of the menus, tap
the system logo.
System Logo
2. At the Enter your code to disarm the system
screen, enter the Duress Code.
Enter the Duress Code
The system will announce “System Disarmed” and return to
the Home screen.
In the Event of a Burglary Alarm
If one or more armed sensors are tripped while the system
is armed in Stay or Away Mode, an alarm condition will
occur, and the system’s alarm siren will sound.
If an Entry Delay sensor is tripped while the system is
armed in Stay or Away Mode, the Entry Delay countdown
starts to give you time to disarm the system. If the system
is not disarmed before the countdown expires, an alarm
condition occurs, and the system’s alarm siren will sound.
If more than one armed sensor is tripped, the system
displays the triggered sensors in chronological order.
Alarms Screen—Multiple Alarms in Chronological Order
Silencing the Alarm Sounder (for False Alarms)
If the system is in an active alarm state, any person with an
active user code can silence the sounder by disarming the
system.
»
If you disarm the system BEFORE the Abort
Window Dialer Delay countdown expires, the
system cancels the alarm and stops the alarm report
from being transmitted to the Central Station.
»
If you disarm the system AFTER the Abort
Window Dialer Delay countdown expires, the
system silences the alarm and transmits an alarm
cancellation report to the Central Station.
NOTE: Consult your installer to determine how
the Alarm Abort Window Dialer Delay feature is
confi gured on your system (15-45 seconds). This
setting specifi es the number of seconds end users
have to manually abort the alarm, in the event of
a false alarm. For ANSI/SIA CP-01-2010 com-
pliance, the default setting is 30 seconds. For UL
1023: Household Burglar Alarm Units compliance,
this setting may be confi gured to a maximum of 45
seconds.