User Manual

The system bypasses the devices and its status

changes to System Ready To Arm (BYPASS).

System Ready to Arm (BYPASS) Status

7. Continue by arming the system. See “Arm the

System.”

After the system is disarmed, bypassed sensors are

automatically removed from the system’s Bypassed

Sensors list, unless the Auto Bypass for Manual Bypass

feature is enabled.

NOTE: Consult your installer to determine if the

Auto Bypass for Manual Bypass feature is enabled.

See the GC3e Installation & Programming Guide.

Removing Sensors from the Bypassed Sensors

List

After the system is disarmed, bypassed sensors are

automatically removed from the system’s Bypassed

Sensors list, unless the Auto Bypass for Manual Bypass

feature is enabled. If you decide you want to remove a

sensor from the Bypassed Sensors list before you arm the

system, use the steps detailed here.

To remove a sensor from the Bypassed Sensors list:

1. At the Home screen, tap System Settings.

2. Enter the Master User Code to access the System

Settings.

3. Tap Bypass Sensors.

4. Move the slide control to the left for the desired

sensor. This removes the sensor from the system’s

Bypass Sensors list.

Bypass Sensor LIst

5. Tap when ﬁ nished.