User Manual

Copyright © 2019 Nortek Security & Control LLC.
59
2. At the Smart Home Settings menu, tap
Rediscover Network.
Smart Home Settings—Rediscover Network
3. At the Rediscover Network screen, tap Start.
Rediscover Network—Start
While the system is rediscovering the network it
displays the status of each node as it is checked.
Rediscover Network—Status
When the rediscovery is complete, the Rediscover
Network screen with the Start button (shown
above) appears again.
Reset the Controller
You can reset the Z-Wave controller to remove all Z-Wave
devices from the network and to reset the controller to its
factory default state.
NOTE: Consult the device’s installation guide for
instructions.
NOTE: Use this procedure only in the event that the
network primary controller is missing or otherwise
inoperable.
To reset the controller:
1. Navigate to the Smart Home Settings menu. See
“Navigate to the Smart Home Settings Menu.”
2. At the Smart Home Settings menu, tap Advanced
Settings.
Smart Home Settings—Advanced Settings
3. At the Advanced Settings menu, tap Reset
Controller.
Advanced Settings—Reset Controller