User Manual

Copyright © 2019 Nortek Security & Control LLC
66
Learn Controller
The GC3e Panel can be added to an existing Z-Wave
network as a “secondary” controller (this process is also
called “copy” or “replication”).
When the GC3e Panel acts as a secondary controller,
devices can only be added to or removed from the Z-Wave
network at the primary controller. Other than that, all
functions are available to either controller.
To add the GC3e Panel as a secondary controller for an
existing Z-Wave network:
1. At the existing controller, add the GC3e Panel to the
Z-Wave network. (If the existing controller is a GC3e
Panel, see “Add a New Device.” Otherwise, refer
to the documentation that came with the Z-Wave
controller.)
2. At the Home screen on the secondary GC3e Panel,
tap System Settings.
Home—System Settings
3. Enter the Master User Code to access the System
Settings screen.
Enter Master Users Code
4. At the System Settings menu, tap Smart Home
Settings.
System Settings—Smart Home Settings
5. At the Smart Home Settings menu, tap Advanced
Settings.
Smart Home Settings—Advanced Settings
6. At the Advanced Settings menu, tap Controller
Learn.
Advanced Settings—Controller Learn
The GC3e Panel displays a “Learning Z-Wave
Controller” message and waits for a signal from the
primary controller. The synchronization takes time,
depending upon the number of Z- Wave devices in
the network.
NOTE: If a new Z-Wave device is added to the
network, the secondary controller must be
re-learned into the network