User Manual

2GIG Gun Motion Detector
SPECIFICATIONS
Wireless Signal Range
350 ft (106.7 m), open air, actual range
may vary based on the wireless control
panel being used.
Code Outputs Supervisory; Low Battery; Movement
Transmitter Frequency 345.00 MHz (crystal controlled)
Unique ID Codes
Over one (1) million different code
combinations
Supervisory Interval 70 minutes +/- 10 minutes
GoControl Sensor Type Tilt Sensor
Sensor Dimensions 2.7 x 2.3 x 1.4 in (69.5 x 57.3 x 36.4 mm)
Weight (including battery & magnet) 7.4 oz (210 g)
Housing Material ABS Plastic
Color Black
Operating Temperature -4° ‐ 140° F (-20° ‐ 60° C)
Relative Humidity 0‐90% Non‐Condensing
Battery (included)
One (1) CR 2032 or equivalent Lithium
battery
Certication
FCC, IC and California DOJ-approved
Firearm Safety Device.
Inserting and Replacing the Batteries
To insert or replace the battery:
1 Remove from your rearm if the Detector is attached.
2 Remove the battery cover.
3 Carefully lift up on the front of the battery and pull straight out.
IMPORTANT: Always dispose and/or recycle used batteries in accordance with the
hazardous waste recovery and recycling regulations for your location. Your city, state,
or country may also require you to comply with additional handling, recycling, and
disposal requirements.
3 Insert the replacement battery. The plus (+) sign of the battery should be facing
up and the minus (‐) side facing down.
4 Replace the battery cover.
WARNING: Failure to follow these warnings and instructions can lead to heat
generation, rupture, leakage, explosion, re, or other injury, or damage. Do not insert
the battery into the compartment in the wrong direction. Always replace the battery
with the same or equivalent type (see Specications, right). Never recharge or
disassemble the battery. Never place the battery in re or water. Always keep batteries
away from small children. If batteries are swallowed, promptly see a doctor.
Bottom View
+
Bottom View
+
Working With Your GoControl
©
Panel
This 2GIG Gun Motion Detector is designed to send an alert transmission to your GoControl panel when there is natural movement. This alert can initiate a number of actions
based on the programming of the GoControl panel.
2GIG-GNGRD1-345 Scenarios – When Attached Gun is Moved
Panel Status Scenario 1 Scenario 2 Scenario 3 Scenario 4
Armed Away Alarm Alarm after entry delay Alarm Local Chime Notication
Armed Stay None None Alarm Local Chime Notication
Disarmed Local Chime Notication Local Chime Notication Local Chime Notication Local Chime Notication
Professional Installer Notes – Setup Conguration
Sensor Type Interior Follower Interior w/ Delay Day Zone No Response
Sensor Equip Type Motion Motion Motion Motion
Storing The 2GIG Gun Motion Detector
The 2GIG-GNGRD-345 will periodically transmit a status signal to the 2GIG Control
Panel. If this device is placed in a safe or locked box the radio transmission may
be impeded. Ask your security dealer about adding a repeater to ensure effective
communications between the devices.
Check with your Alarm Monitoring Company on how to set up push notications to your smartphone.
Reset Button
3 With dials set to the current combination, use a pen point or similar narrow object,
press the Reset Button on the left side of the lock in toward the center of the
lock.
4 Continue to apply pressure to the reset button, and set the dials to your
personalized combination.
5 Release the Reset Button, new combination is now set.