Manual

INSTALL INSTRUCTIONS

Theseinstructionsarewrittenforusewheninstallinga2GIG‐GCPOTSModuleintoa2GIGControl

Panel.

Box Contents

•POTSModule

•InstallInstructions

INSTALLING

1 RemovethebackplateoftheControlPanel.Thefollowingfigureshowsthebackofthe

ControlPanelwithoutaPOTSModuleinstalled.

2 Matchthe7x2pinsetandthe2whitemountingclipsonthebackofthePOTSModuletothe

openpinsetand2holesonthebackoftheControlPanel.

3 PushthePOTSModulegentlydownontotheControlPaneluntilitsnapsintoplace.

POTS MODULE

PAGE 1
POTS MODULE INSTALL INSTRUCTIONS These instructions are written for use when installing a 2GIG‐GC POTS Module into a 2GIG Control Panel. Box Contents • • POTS Module Install Instructions INSTALLING 1 Remove the back plate of the Control Panel. The following figure shows the back of the Control Panel without a POTS Module installed. 2 Match the 7 x2 pin set and the 2 white mounting clips on the back of the POTS Module to the open pin set and 2 holes on the back of the Control Panel.
PAGE 2
4 Check to ensure that the back of the Control Panel with the POTS Module looks like the following figure. Un-installing the POTS Module Because the white mounting clips snap into place, you will need a pair of needle‐nosed pliers before proceeding. 1 Using the needle‐nosed pliers, pinch the barbs on the white mounting clips that are protruding from the top of the POTS Module. 2 Carefully slide the POTS Module straight up.