User guide

Table of Parameters 3.2

Every table line includes a prefix (of variable length) plus parameters that define

EasyGate's behavior in case the beginning of the dialed number matches this prefix.

The table can contain up to 20 different prefixes.

There may be exceptions to the rule - a number may start with the same digits but

has to be served in a different way. Any table line that starts with the same prefix

followed by one or more digits is considered an exception of the line with shorter

prefix.

Remember to complete the "Other numbers" line for a number whose prefix is not

included in the table.

An example in the figure below shows how to bar all international calls with the

exception of calls to Slovakia including dialing acceleration by selecting the number

length parameter and tariff setting (5 impulses after call connect and then one

impulse every 10 seconds). All other calls are enabled and their tariff is one impulse

every 30 second.

Operator for Integra Function No.: -

In some GSM networks you can add to dialed number # character and PBX

subscriber number. Subscriber number is displayed on other side together with

CLI. This parameter take place when dialed number doesn't contain # character.

Setting options: 0-8 characters (0-9)

Default setting: blank

Routing table enable Function No.: 20

Enable the use of the routing table with this parameter. Disabling this parameter

you put the table out of use.

Setting options: YES/NO

Default setting: NO

Figure 3.2

Routing table