User guide

Voice function 4.1

4.1 Voice function

Outgoing and incoming call establishing procedures for an analog telephone are

described for illustration. The procedures are the same for the EasyGate-PBX

connection, just remember to program call routing to EasyGate properly. Check

EasyGate’s function by connecting a telephone before.

Suppose that a SIM card has been inserted, the PIN code entered or not required, the

antenna connected and EasyGate registered to GSM network – the GSM network LED

is permanently on and you can hear the dial tone upon off-hook.

Outgoing Call

1. Hook off the telephone, you can hear the dial tone and the Line LED starts

flashing.

2. Dial the required GSM subscriber number. Since EasyGate receives tone

dialing by default, select the DTMF mode. If your telephone transmits pulse

dialing only, program EasyGate to receive pulse dialing. The delay between

digits to be dialed may not exceed 5 s (programmable parameter). The number

is evaluated as complete and transmitted to the GSM network after this timeout.

3. A short delay follows the last-dialed digit for EasyGate to await further dialing.

Then, the dialing end is signaled and connection is established.

4. If the called subscriber is available, you can hear the ringing tone. If not, you

can hear the busy tone or any of the GSM provider’s messages.

5. When the called subscriber answers the call, a call is established. The Line

LED is permanently on during the call.

6. Hang up to terminate the call. The Line LED goes off. If the called subscriber

is the first to hang up, you can hear the busy tone and hang up.

Incoming Call

1. Ringing signals an incoming call. The Line LED flashes during ringing. If

programmed so, EasyGate transmits the CLIP by FSK between the first and

second rings. Advanced telephone sets are able to display the CLI.

2. Hook off the phone to establish the call. The Line LED is permanently on

during the call.

3. Hang up to terminate the call. The Line LED goes off. If the called subscriber

is the first to hang up, you can hear the busy tone and hang up.

Automatic Call ("Baby Call")

If the BabyCall function is enabled, a pre-programmed period of time is counted down

after off-hook. If you do not start dialing within this timeout, EasyGate signals dialing

end and starts establishing a call to the pre-programmed number automatically – from

now on EasyGate behaves as if a standard outgoing call had been established. Any