User manual, 1510 v1.13 Owner's manual

Configuration
3.3
102
Flash – re-pushing the quick dialling button sends the FLASH signal into the
active call.
Quick dialling using digits
Enable user calling from the telephone directory by dialling the user number (two
or three digits) and confirmation with *.
Floor & Apartment dialling
Enable special calling to numbers included in the telephone directory by entering a
floor number on the numerical keypad and pushing a quick dialling button.
Buttons 1 – 6 represent apartments on the floor (A through F). The following
floors and apartments are assigned to telephone directory positions: 01A – 1, 01B
– 2, 01C – 3, 01D – 4, 01E – 5, 01F – 6, 02A – 7, 02B – 8 etc. until 99F – 594.
Keystroke timeout
Set the delay between two digits when entering a code or telephone number using
the 2N
®
Helios IP keypad.
Enable telephone mode
Enable to set up calls directly to the telephone numbers entered from the
2N
®
Helios IP numeric keypad using the *telephone_number* key sequence.
Dial digits limit
Define the maximum number of digits of a telephone number in the Telephone
mode. When the defined count is reached, the telephone number is dialled
automatically without the need to push * subsequently.
Legacy lock code
Set whether the first code in the lock 1 and lock 2 list may be entered from a VoIP
phone valid without an * confirmation.
Other Settings
Backlight level
Set the level of the keypad backlight.
DHCP on/off by buttons
Set whether a quick dialling button combination may switch to obtaining the IP
address from the DHCP server upon the 2N
®
Helios IP restart as described in the
Switching to Default Network Parameters – Dynamic IP Address subsection.
Enable lock control by HTTP
Enable lock control by HTTP requests sent by 2N
®
Helios IP. Select ON, OFF or
change over upon the following HTTP (GET) request:
http://helios_ip_address/enu/lockstate.xml.p?lockXstate=Y, where X is the lock
number (1-4) and Y is 0 for switch off, 1 for switch on and 2 for change over.