User manual, 1510 v1.13 Owner's manual

Acoustic Signalling and Keypad Configuration

3.1

$HeliosId$ 2N

Helios IP identifier

Miscellaneous subsection.

Internal application launched

after turning on or restarting of 2N

Helios IP, the internal

application of 2N

Helios IP is launched. A successful launch is

signalled by this tone combination.

Connected to LAN, IP address received

after the launch of the internal application 2N

Helios IP logs into

the LAN. A successful login is signalled by this tone combination.

Disconnected from LAN, IP address lost

whenever the UTP cable is disconnected from 2N

Helios IP, this

status is signalled by this tone combination.

Invalid telephone number or invalid unlocking code

you can dial an extension telephone number or enter the door-

opening code using the keypad. An invalid code is signalled by

this tone sequence.

Switching to default network parameters

after power up, a 30-second timeout is set for entering the

resetting code. For switching to default network parameters refer

to the Switching to Default Network Parameters – Static IP

Address and Switching to Default Network Parameters – Dynamic

IP Address subsections.

Call end signalling

a time limit can be set after which your call will be terminated. To

prolong a call, push a VoIP telephone key. The time limit is set

due to protection against call blocking.

Connected call for VoIP phone-to-2N

Helios IP calling

a short tone is played to signal call connection.

Table 3.1 List of Tone Signals

Switching to Default Network Parameters – Static IP

Address

Switching to the default network parameters with the static IP address can be

performed in two ways. Either through a web interface as described in the Network

subsection or by pushing a combination of the quick dialling buttons as shown in

Figures 3.1–3.3. Upon resetting, the web server is automatically switched on if

switched-off before. The buttons have to be entered within 30 seconds after the

internal application launch as signalled by the tone sequence. The maximum

delay between the buttons is 2 s.