User manual, 1510 v1.13 Owner's manual

Configuration

3.3

Lock mode

Select either the mono-stable and bi-stable lock switch mode. The switch is

automatically switched off after a predefined switch-on time in the mono-stable

mode. The first activation opens and the second activation closes the switch in the

bi-stable mode.

Switch-on duration

Set the lock switch-on time in the mono-stable mode. The time interval set here is

not applied to the bi-stable mode.

Sound signalling

Set the sound signalling type during lock switch-on status. Select one of the

following: Short tone, Long tone (during the whole switch-on time), or a User

sound, refer to Subs. User Sounds.

Display info

Enable or disable displaying of lock switch-on signalling.

Output relay

This option helps you assign a switching relay to the lock: Basic switch or

Additional switch (Part No. 9137310E), and/or a reader switch: Reader switch

#1, Reader switch #2 if the RFID card reader is installed (Part No. 9137430E).

Synchronise with

Enable lock synchronisation for automatic lock switch activation after a predefined

time interval after another lock switch activation. Use the Synchronisation delay

parameter to set the timeout value.

Synchronisation delay

Set the time interval for synchronised activation of lock switches. The parameter

is not applied if the Synchronise with function (above) is not enabled.

Activate by call

Set lock activation by an incoming/outgoing call. The switch is active during the

whole call in the bi-stable lock switch mode. The switch is activated by the call

start and deactivated after a predefined switch-on time in the mono-stable mode.

Quick dial button

Assign one of the speed (quick) dial buttons to the lock switch. Push this speed

dial button to activate the lock switch. Once assigned to a lock switch, this button

cannot be used for dialling.

External command

Switch-on command

Set the command to be sent to an external device (WEB relay, e.g.) via the HTTP

protocol (GET request) whenever the lock switch is activated. The required format

is http://ip_address/path. Example: http://192.168.1.50/relay1=on.

Switch-off command