User manual, 1510 v1.13 Owner's manual

Configuration
3.3
72
Set the command to be sent to an external device (WEB relay, e.g.) via the HTTP
protocol (GET request) whenever the lock switch is deactivated. The required
format is http://ip_address/path. Example: http://192.168.1.50/relay1=off.
Lock Codes
A list of the universal lock codes to be entered using a telephone set or the 2N
®
Helios
IP keypad. The count of these global lock codes is 10 (or 2 for Part Nos.
9137131(CK)E, 9137161(CK)E, 9137111(CK)E unless a licence key is used, Part No.
9137901). In addition to these ten codes, each user may be assigned a user-dedicated
unlocking code (for Part Nos. 9137131(CK)E, 9137161(CK)E and 9137111(CK)E with a
licence key only, Part No. 9137901.)
Access
Disable code entering from the user‘s numeric keypad or telephone set.
Time profile
Assign a time schedule to the lock code for validity management. Refer to the
Scheduler subsection for details on time schedule settings.
Lock code options
Enable ON/OFF mode
You are recommended to enable different activation/deactivation codes while
setting the bi-stable lock mode. Use this parameter to set a mode where odd
codes (1, 3, 5, etc.) are used for lock switch activation and even codes (2, 4, 6,
etc.) for lock switch deactivation. If this mode is OFF (default setting), then you
can use any code to turn the lock switch into the opposite state (ON/OFF). This
does not apply to the mono-stable lock switch mode where the activation time is
prolonged.