Owner's manual

1112N TELEKOMUNIKACE a.s., www.2n.cz
®
Programming Procedure
Having entered the programming mode, you can change any programmable value(s) in
any order. Proceed as follows: enter the function number and then the value. Use an
asterisk as a separator or Enter. In general, the function has the following format:
function number value
The function number has three digits (see the table). After you enter the function
number and an asterisk, reports the number or name, current value and potentialL8
range of the parameter to be programmed. After you enter the value and another
asterisk, reports “New value stored”, or “Invalid value, new value not stored” if theL8
value is beyond the allowed range.
L8 reads out the parameter number and the newly configured value for checking
purposes.
Programming Error
If you make a mistake during entering (the function number or value) and have
not entered an asterisk yet, you can cancel the whole number by pressing
and re-enter the number.
If rejects the parameter number or value you have entered, go onL8
programming but re-enter the function number even if only the value was wrong.
If you have programmed and stored a value other than the required one, you can
re-enter the value of course.
Programming End
If you are calling via a telephone number, hang up to terminateL8
programming.
If you are programming via the machine room Audio Unit, press and hold over 2
s to terminate programming and put the Audio Unit in the standby mode.
If you only want to go one menu back, press .
Warning
A drawback of some telephone sets is that, after you press a button, i.e.
send a DTMF signal, they go “deaf” for a fraction of a second. In that
case, you cannot hear the whole text and are recommended to use
another telephone.
Tip
If you are not quite sure of how will behave after programming, saveL8
the filled-in form for later check.