Owner's manual

1192N TELEKOMUNIKACE a.s., www.2n.cz
®
and 4 will be on after the
system start.
507
Default
output state
of IO module
7
ABCD empty
508
Default
output state
of IO module
8
ABCD empty
600
Battery
capacity
1–740 13
In 100mAh units
(x*100mAh "13=1,3Ah,
740=74Ah")
700 SIM PIN
up to 16
digits: 0–9
0000
710
DTMF
transfer
enhanced
mode
enabled
0–1 0
0 = disabled, 1 = enabled
If there is a DTMF transfer
problem in the GSM
network, enable this
parameter.
901 Dial prefix
up to 30
digits: 0–9 empty
Dial-in is used for calling
via the PSTN module. When
a call is answered, the
dial-in is sent and only then
the dialling or constant
tone is awaited.
When the tone is detected,
a number is dialled from a
memory (common dial-in
for all memories: 011–016,
021–026, 071–076,
081–086).
909
Time for tone
detection
after
hang-up
1000–9999 ms 5000 ms
waits for the constant orL8
dialling tone. If none is
detected, there is a fault on
the line (PSTN only).
911
Count of
rings before
incoming call
pick-up
1–9 2
Define the moment of line
pick-up during ringing (if
there is an incoming call
from PSTN).
912
Max. call
time
0–1000 s 120 s
The call can be extended by
a call-extending command
(parameter 924).
0=disabled (never-ending
call).
913
Login time
limit
10–1000 s 60 s
Maximum period during
which the control centre
staff must answer the call
and send confirmation,
otherwise hangs up andL8
proceeds to dialling the
next number. Counted from
the end of dialling.