Owner's manual
Table Of Contents
- 1. Product Introduction
- 2. Description and Installation
- 3. System Configuration
- 4. Function and Use
- 5. Service Tool
- 6. Server
- 7. Control Panel
- 8. Communicator
- 9. Maintenance
- 10. Technical Parameters
- 11. Supplementary Information
1292N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2.
3.
4.
5.
4.2 Control Centre Instructions
ALARM Call
Press the ALARM button on any audio unit to make call the control centreL8
(refer to Automatic Dialling for details).
A received call is either confirmed as configured (parameters 111–116 >
Confirmation mode for memory 1–6 ALARM call – set 1). By default,
is set in .confirmation of DTMF 1 L8
If the control centre is equipped with the , youCommunicator2N
®
application
can configure automatic sending of DTMF 1 after call pick-up.
The call is time limited (press button 4 upon warning announcement “Caution,
the call is ending” to extend the call).
You are recommended to end the by pressing 5 or #.
Control Room-to-Lift Calling
The control centre can also call back to the communicator. The automaticallyCU
receives every incoming call, identifies itself and, via a voice menu (DISA), offers you
another function to get through to the required . Incoming calls are timeaudio unit
limited as outgoing calls and are processed in the same way (extension, termination).
Incoming Call Voice Menu
Welcome, this is a Lift 8 communicator2N
®
Press 0 for connection with the last-calling audio unit
Enter the lift number X to dial another audio unit
Press 1 to dial the lift cabin
Press 2 to dial the cabin roof
Press 3 to dial the lift bottom
Press 4 to dial the shaft bottom
Press 5 to dial the machine room
Press # to return to the main menu
Press 9 for administration
Press 1 to enter the programming menu
Press 2 to terminate the rescue process
Press 3 to listen to your communicator info
Press # to return to the main menu
o end the callPress # t
The menu above makes it possible to call the selected .audio unit
Caution
Press # to go one level back in the voice menu.
You can also terminate a call using #, but only on the highest voice menu
level: Press 0 for connection with the last-calling , Enter the liftaudio unit
number X for connection with another , Press 9 foraudio unit
administration, information or rescue process, and Press # to end the call.