Owner's manual

1302N TELEKOMUNIKACE a.s., www.2n.cz
®
Tone Dialling Control during Call – Long Command List
Where automatic dialling with confirmation is used, it is possible to use tone dialling for
control during the call according to the table below. For simplification, commands 1L8
to 5 are arranged in the sequence they are usually used in.
DTMF
symbol
Description of function
Only where automatic dialling repetition is enabled (with confirmation
This symbol is used to a successful call to . DTMF 1). confirm L8 L8
mutes the played-back announcement and, optionally, sends the
identification code (DTMF). The call goes on until the timeout end and
any of the following commands may be used.
Repeated voice module for one replaying of theplayback
announcement.
Call extension. The call is extended as defined in parameter 912
(120 seconds by default) upon this command. Can be used
repeatedly.
or
Call termination (does not work until the call is confirmed).
This table applies to the Automatic voice dialling with confirmation mode.
Calling to lift which was the last to call Alarm
Having entered the voice menu, press 0 to call the lift was the last to dial
the Alarm function.
This function operates only if you are calling to via a PSTN, GSM, UMTSL8
or VoIP network.
Note
The 9 selection serves primarily for the L8 configuration – refer to the
Configuration section.
Warning
Rarely, may not identify the above listed commands reliably duringL8
message playing or voice communication. This is due to the essential
principle of the telephone line function where DTMF signalling is mixed
with the call and thus may be masked by certain speech tones or noise.
This, however, is not a defect of the product.