Owner's manual
Table Of Contents
- 1. Product Introduction
- 2. Description and Installation
- 3. System Configuration
- 4. Function and Use
- 5. Service Tool
- 6. Server
- 7. Control Panel
- 8. Communicator
- 9. Maintenance
- 10. Technical Parameters
- 11. Supplementary Information
1432N TELEKOMUNIKACE a.s., www.2n.cz
®
1.
2. Enter the programming mode via the voice menu (incoming call or machine room
) and set the shaft number to the ALARM memory (011–016). Thenaudio unit
choose parameter 017 (refer to the Table of Parameters) and add the required
character (#) to one of the ALARM memories.
Caution
Configure the alarm-intercom connection for calls to the machine room
of any shaft (1–8).audio unit
Identically, configure the machine room – control centre connection for
ALARM set 2.
Make sure that the control centre is of the machineaudio unit
room type.
You can use confirmation mode 1 or 2 for calling to a machine room audio
. With the other options (3–6), the call is processed as if 1 wasunit
selected.
Note
It is possible to combine calling to the machine room (control centre)
with calling via the PSTN, GSM, UMTS and VoIP networksaudio unit
(depending on the module used).
To set up a check call to a machine room , you can set theaudio unit
number as described in the Alarm – Intercom subsection above.