Owner's manual

Table Of Contents

1882N TELEKOMUNIKACE a.s., www.2n.cz

Intercoms – General MenuFigure:

The Checking call period specifies the timeout within which the intercom must call the

r or after which makes active check calls. The2N Lift8 Serve

2N Lift8 Server

intercom can call the any time within this timeout, but having2N Lift8

Server

exceeded this value, it will be marked as defective. The non-functional status will be

removed when another check or alarm call arrives in the server from this intercom. The

default value of this parameter is 72 hours. The Alarm call response specifies the type

of alarm call processing: , anNormal call Confirm with 1, CPC Antenna, CPC KONE

d Similarly, the Check call response specifies the type of check call processing: P100.

, , , andReject Accept and send 5 Confirm with 1 and 5 CPC Antenna, CPC KONE

. Complete the serial number of your intercom in the Serial number field. P100

Together with Password, this parameter is relevant for a correct function of the data

tunnel. The default password is 2n. Click Save to confirm the setting. If you select the

type, set the outgoing check call parameters too: select Active check calls2N Helios

to enable active check calls for the selected intercom, complete First run to define the

first check call and Next run to define the next check call to the intercom. Complete the

Unsuccessful call repeat count to specify how many check call attempts are to be made

before the system detects an error and executes the action set in the Call server.