Owner's manual
Table Of Contents
- 1. Product Introduction
- 2. Description and Installation
- 3. System Configuration
- 4. Function and Use
- 5. Service Tool
- 6. Server
- 7. Control Panel
- 8. Communicator
- 9. Maintenance
- 10. Technical Parameters
- 11. Supplementary Information
1962N TELEKOMUNIKACE a.s., www.2n.cz
®
SIP Settings
Every user authorised to use the must be assigned a SIP2N Lift8
®
Communicator
line, i.e. an account registered with a SIP provider or the PBX used for login via the 2N
. When you log in to the application, your line will get Lift8
®
Communicator
registered and you can process the calls coming to your line depending on the 2N
®
configuration. An incoming alarm call will probably dial Dispatcher account Lift8
number. Dispatcher can then contact Technician if necessary. Refer to S.8, 2N Lift8
®
, for details on these functions. Set the following SIP line parameters inCommunicator
the menu: SIP server and Registrar server, i.e. the server via whichCommunicator
the SIP client will register and calls will be made. Enter the IP address/domain of the
SIP Proxy server: port 5060 is used by default. If your provider uses a different port,
add this port to the Domain parameter behind a colon as shown in the figure below.
Set the Domain to differentiate Proxies within a PBX, Username and provide/PBX SIP
account Password. Registration expiry is the last configurable parameter. Click Save to
confirm the settings.
Users – SIP Settings MenuFigure:
Caution
Make sure that the SIP line is configured correctly to register your SIP line
and log in to the application.2N Lift8
®
Communicator
Contact your network administrator for the SIP line settings.