Owner's manual
Table Of Contents
- 1. Product Introduction
- 2. Description and Installation
- 3. System Configuration
- 4. Function and Use
- 5. Service Tool
- 6. Server
- 7. Control Panel
- 8. Communicator
- 9. Maintenance
- 10. Technical Parameters
- 11. Supplementary Information
2022N TELEKOMUNIKACE a.s., www.2n.cz
®
The List of available lines displays all of the 8 lines to be configured. Each line includes
identification and state parameters: Domain specifies the domain with which the line is
registered, Active shows whether the line is currently on/off and Active calls counts the
current calls via the line. If Active calls is zero, there is no active incoming/outgoing
call on the line. The Active check call function is enabled for the first line.
Call Server MenuFigure:
General
The menu consists of two parts: for all the lines and . ServerGeneral Server Line
provides the current SIP server state information: Maximum simultaneous calls
displays the maximum count of check calls to be processed by the server at the same
time. If more calls than as defined in the parameter arrives in the server at one
moment, all the excess calls will be rejected. Call server state signals the current state
of the server: Starting, Running, Waiting for reconfiguration and Error.
Caution
Set the SIP lines in the Use the settings of the PC on2N Lift8 Server!
®
which the server is installed instead of your PC settings. Your PC settings
will be applied only if the server runs locally.