Owner's manual
Table Of Contents
- 1. Product Introduction
- 2. Description and Installation
- 3. System Configuration
- 4. Function and Use
- 5. Service Tool
- 6. Server
- 7. Control Panel
- 8. Communicator
- 9. Maintenance
- 10. Technical Parameters
- 11. Supplementary Information
2312N TELEKOMUNIKACE a.s., www.2n.cz
®
Incoming Call Pop-Up WindowFigure:
See the figure below for the Incoming call window. The upper part displays the
currently speaking intercom name and phone number and one of the following
Application states to the right:
Ringing... – the selected outgoing/incoming call is just ringing.
Speaking... – the call was answered by both the subscribers and is in progress.
Call terminated – the call was terminated correctly.
Call rejected – the outgoing call was rejected by the counterparty.
Missed call – the incoming call was not served. Ringing stopped before the
dispatcher answered the call.
The left-hand part of the screen provides information on the given intercom: Name,
Intercom identification, Contact number and Address. Use the keypad below these
items to control the Speaking call: confirm the call with DTMF or dial the required shaft
number. A calling technician can use the keypad for the voice menu control. PressCU
a button to send the particular DTMF character into the call. If the intercom address is
completed, the intercom location is displayed on the map below the keypad. Use the
slider in the left-hand upper corner to zoom in/out.
Tip
No matter where you pick up the call (whether in the application or the
pop-up window), the system always behaves identically.