Owner's manual
Table Of Contents
- 1. Product Introduction
- 2. Description and Installation
- 3. System Configuration
- 4. Function and Use
- 5. Service Tool
- 6. Server
- 7. Control Panel
- 8. Communicator
- 9. Maintenance
- 10. Technical Parameters
- 11. Supplementary Information
402N TELEKOMUNIKACE a.s., www.2n.cz
®
Termination Resistance
Figure: Termination Resistance Off
Caution
Find the 3-pin termination resistance connecting jumper between the
main bus connector and lift number switch.
Connect the jumper to the first and last device (CU, splitter or I/O
module) on the bus. Refer to the CU describing section for more details on
termination resistance mounting.
By default, the termination resistance jumper is off.