Owner's manual

692N TELEKOMUNIKACE a.s., www.2n.cz
®
Procedure
Rotary switch
position
Figure
1. Insert the hexagonal
spanner (included) in the
hole
on the product bottom edge
(window lock screw) and
turn left (about 10 times)
until you feel resistance.
Position 1 – ALARM
normal, CANCEL
normal, cabin
2. The window slides down
by itself or with a slight aid,
revealing its upper brim.
Position 2 – ALARM
inverted, CANCEL
normal, cabin
3. Tilt the window forward
and remove it.
Position 3 – ALARM
normal, CANCEL
inverted, cabin
4. Set the required address.
Position 4 – ALARM
inverted, CANCEL
inverted, cabin
5. Replace the window. Position 5 – cabin roof
6. Insert the hexagonal
spanner (included) in the
hole on
the product bottom edge
(window lock screw) and
turn right
(about 10 times) until the
window slides under the
panel edge.
Tighten slightly.
Position 6 – cabin
bottom
Position 7 – shaft
bottom
Positions 8, 9, 0 / not
used (red bus LED
flashing)
ALARM and CANCEL Setting (Rotary Switch)
Contact closing/voltage connection control of ALARM and CANCEL
Set the rotary switch (under the front glass) to position 1 to make
ALARM/CANCEL be controlled by contact closing or voltage connection.
Contact opening/voltage disconnection control of ALARM, contact
closing/voltage connection control of CANCEL
Set the rotary switch (under the front glass) to position 2 to make ALARM be
controlled by contact opening or voltage disconnection and CANCEL be controlled
by contact closing or voltage connection.