Owner's manual
Table Of Contents
- 1. Product Introduction
- 2. Description and Installation
- 3. System Configuration
- 4. Function and Use
- 5. Service Tool
- 6. Server
- 7. Control Panel
- 8. Communicator
- 9. Maintenance
- 10. Technical Parameters
- 11. Supplementary Information
722N TELEKOMUNIKACE a.s., www.2n.cz
®
a.
b.
c.
Figure: Mounting of Audio Unit – Cabin Compact
If the cabin wall is thin (stainless steel sheet), use the four M4 screws of
the length of 8 mm and fan washers included in the delivery.
If the cabin wall is thick (up to 20 mm – laminated chipboard, e.g.), use
the four M4 headless screws of the length of 30 mm. Screw the screws into
the audio unit backside holes with the enclosed spanner and tighten them.
Then push the set through the pre-drilled holes and insert the fan washers
and nuts from the back.
If you cannot access the cabin wall from the rear, follow the instructions on