Owner's manual
Table Of Contents
- 1. Product Introduction
- 2. Description and Installation
- 3. System Configuration
- 4. Function and Use
- 5. Service Tool
- 6. Server
- 7. Control Panel
- 8. Communicator
- 9. Maintenance
- 10. Technical Parameters
- 11. Supplementary Information
852N TELEKOMUNIKACE a.s., www.2n.cz
®
Figure: Cabin Audio Unit – Universal Mounting Hole Dimensions
To mount the unit, you need 4 electrically spot-welded (from the inner panel side) M3
or screws, a sufficiently perforated speaker area and a microphone hole. If needed,M4
a high-quality double-sided foam self-adhesive tape can be used for installation on a
perfectly degreased surface.
Warning
Leave no gap between the lift control panel and the audio unit surface to
avoid acoustic speaker fault and acoustic speaker-microphone feedback.
this type of audio unit Do not use otherwise than mounted on a
sufficiently large board. The acoustic properties of an uninstalled audio
unit cannot be guaranteed.