User guide

42 • Operating Instructions DigiCart/II Plus Owner's Manual
CAUTION
IF YOU COPY TO AN OCCUPIED DESTINATION, THE CONTENTS AT
THAT DESTINATION WILL BE REPLACED.
ALWAYS TAKE A MOMENT TO BE SURE OF WHAT WILL HAPPEN
WHEN USING COPY.
COPYING A CUT
Copies the entire contents of the current cut from its original location to any other location.
1. Navigate to the cut you wish to copy (source cut).
2. Press the UTILITY MENU button and rotate the SELECT control until the display
shows:
COPY ORIGINAL
PRESS ENTER/CANCEL
3. Press the ENTER button. The display will show:
X.XXXX CUT NAME
SELECT DESTINATION
4. If necessary, use the POSITION buttons and the SELECT control to select a
different destination directory.
5. Press the Right POSITION button. If the directory is empty, Press the ENTER
button. The display will show:
TARGET ID
SELECT NEW INDEX #
6. If the diectory is not empty, use the SELECT control to view the existing contents
of the directory or select a particular cut to be replaced.
7. Press the ENTER button. The display will show:
TARGET ID
REPLACE OR SELECT #
8a. To replace the selected cut: Press the ENTER button.
The display will briefly flash:
COPYING
TARGET ID NEW NAME
OR