User Manual

13
Connecting Instant Replay to External Audio Equipment
The rear panel of the Instant Replay is shown in Figure 3.
Connecting Input Sources
Connect Balanced stereo analog sources to the BALANCED INPUT stereo pair.
Connect Un-balanced stereo analog sources to the UNBALANCED IN stereo pair.
Note: These inputs are mixed together internally and are both active whenever the
AUDIO Input is set to ANALOG.
Connect a digital AES/EBU source to the AES/EBU DIGITAL IN connection.
Connect a digital IEC-958 RCA source to the IEC-958 II RCA jack.
The input source used for recording is selected via the AUDIO INPUT menu under the RECORD
SETUP. See Page 14.
Connecting Monitoring Equipment
Connect Balanced stereo analog monitors to the BALANCED OUTPUT stereo pair.
Connect Un-balanced stereo analog monitors to the UNBALANCED OUT stereo pair.
Connect a digital AES/EBU monitor to the AES/EBU DIGITAL OUT connection.
Connect standard stereo headphones to the ¼” headphones jack ( far left ).
Cuts will be played on all outputs at all times with one exception. When the PREVIEW key is lighted,
Cuts will be played only to the headphone output.
Refer to Page 43 for technical details about audio connections.
FIGURE 3 - INSTANT REPLAY REAR PANEL