User Manual
17
Erasing a Cut
Erasing a cut will permanently delete the cut from the disk. There are two ways to erase a cut.
1. From the Display Module Menu Front Panel
2. Using FTP with the network connection.
The Display Module method works fine for most cases. If you need to erase a lot of cuts, it may
be easier to use the network connection. See the example of this on Page 35.
To ERASE a Cut using the Display Module Front Panel:
Disable the RECORD ERASE LOCKOUT if necessary
Press MENU->RECORD SETUP->RECORD/ERASE LOCKOUT then ENTER
The parameter should be set to OFF.
Select the cut
Select the cut in the Display Module window using the SCROLL KEYS.
Erase the Cut
Press MENU->OPERATIONS->ERASE then press ENTER.
Instant Replay will Prompt
ARE YOU SURE?
PRESS ENTER/CANCEL
Press ENTER to erase the cut. Press CANCEL to cancel the operation.
If you pressed ENTER, Instant Replay will scroll to the next cut. By pressing ENTER
twice you can erase this cut as well, then the next cut and so on. This is a good way to
get rid of lots of cuts at once.
Assigning a Cut to a Hot-Key
The A
SSIGN
H
OT
-K
EY
button lights when pressed and the display prompts for selection of a H
OT
-
K
EY
. Pressing a H
OT
-K
EY
immediately assigns the Cut shown in the top line of the display to that
H
OT
-K
EY
, overwriting any previous assignment.
You do not need to clear a Hot-Key before assigning a new Cut, assignments can be simply
overwritten.
The same audio Cut may be assigned to keys in different banks. If a Cut is assigned to keys in
several different banks, reassigning a new Cut to one key will not disturb assignments in other banks.
For example, if a station ID is assigned to Hot-Key #1 in each of four different banks (1, 2, 3, and 4),
and you reassign Hot-Key #1 in bank 4 to a different Cut, then the station ID remains assigned in
banks 1, 2, and 3.
You can select other Cuts to be assigned using the S
CROLL
A
RROW
keys or F
IND
. With the new Cut
selected, press the H
OT
-K
EY
you wish to assign it to.
To exit, press A
SSIGN
H
OT
-K
EY
again, or CANCEL.