User Manual

21
Using the Playback Sample Rate Converter
There are three ways to set the sample rate of a Cut being played.
1. At the same sample rate it was recorded
2. At a specified sample rate ( 44.1K or 48K )
3. At a rate determined by the AES/EBU or IEC958 II input clock
To play a cut at a user-specified sample rate.
Press MENU->CONFIGURATION->PLAYBACK SAMPLE RATE Then Press ENTER
• Select OUTPUT AT 48K to play the cut at 48Kb/S
• Select OUTPUT AT 44.1K to play the cut at 44.1Kb/S
• Select SYNC TO DIGITAL IN to play the cut at the rate of the AES/EBU or IEC958 II
input clock
• Select AS RECORDED to play the cut at the rate it was recorded ( this is the default )
Press ENTER to complete the selection