Manual

page 34 Instant Replay Owner’s Manual
Enabling a Feature Set
The Select Feature Set option lets you choose the software version under which Instant Replay
will operate. It is only available through a special "power-on" sequence.
To Select a Feature Set
1. Turn Instant Replay's power switch OFF.
2. While holding down the STOP button, turn power ON. The display will prompt:
FORMAT & ERASE DISK?
PRESS ENTER/CANCEL
3. Press CANCEL to proceed. The display prompts:
DEFRAGMENT DISK?
PRESS ENTER/CANCEL
4. Again press CANCEL to proceed. The display prompts:
SELECT FEATURE SET?
PRESS ENTER/CANCEL
5. Press ENTER to proceed, press CANCEL to abort. If you press CANCEL, Instant Replay
will start up utilizing the previous Feature Set. If you press ENTER, the display prompts:
1 FACTORY INSTALLED
2 FIELD UPGRADE
6. Press Hot-Key #1 for the original factory installed Feature Set, or press #2 for the Feature Set
installed using SoftCode. The display will prompt:
360 SYSTEMS
INSTANT REPLAY
followed by software version numbers for the operating system and DSP code. The display
will then return to the normal "Play Ready" state.
TTTTTT