Owner's manual

Page 64 Using Menus
360 Systems
Copy File or Directory
A File may be copied within a Directory, or from its original location to a new
destination Directory on the Internal or External disk. The target Directory must be set to the
same Sample Rate as the source directory or file Select a File or Directory, then select COPY
FILE. You can also select a File and press the COPY key. The display shows:
SELECT DESTINATION DRIVE
(INTERNAL)
AND PRESS 'ENTER' TO CONTINUE
The center line showing the INTERNAL Drive in this example can be changed to
EXTERNAL if an External Drive is connected. Press the ARROW KEYS or rotate the SCRUB
WHEEL until the desired destination Drive appears then press ENTER to confirm the selection.
The display then shows:
SELECT DESTINATION DIRECTORY
(PUBLIC DIRECTORY)
AND PRESS 'ENTER' TO CONTINUE
The center line showing the Public Directory in this example can be changed to indicate
any other Directory. Rotate the SCRUB WHEEL until the desired destination Directory appears,
then press ENTER to confirm the selection. A Directory may also be selected using the NUMERIC
KEYS to enter the Directory number; a "0" (zero) or "P" may be used for the Public Directory.
If a single file is being copied, the display now prompts for a new name for the File;
however, it is not necessary to change the existing name when copying to a different Directory.
ENTER DESTINATION FILE NAME
____________________________
PRESS 'ENTER' TO COPY
Upon pressing ENTER, the file will be copied, unless there is already a file with the
specified name in the destination directory. If there is a duplicate, the display will prompt for
another file name for the copy.
If a Directory is being copied, there is a choice of how to handle duplicate filenames
should any be encountered during the copy operation. The display will show:
REPLACE FILES WITH THE SAME NAME?
PRESS ‘ERASE’ TO REPLACE FILES
PRESS 'ENTER' TO SKIP FILES