Owner manual

TCR Series UserManual Operations 4-11
Using the Locate Register
Entering Locate Values Directly
From the Transport Screen enter the desired time code position using the numeric keypad. After
typing the first digit (or by pressing ENTER) the value entry prompt appears. Continue entering the
desired location, then press ENTER when finished.
Adjusting Locate Values Using the Knob
From the Transport Screen, press ADJUST todisplay the prompt for the Locate (LOC) value.
FILE
LOC 00:01:23:08
.00
POSN
USE WHEEL OR ARROWS TO ADJUST LOC VALUE
PRESS 'ADJUST' OR 'ENTER' WHEN FINISHED
EDIT IN = CURSOR <--
EDIT OUT = CURSOR -->
EXIT = CANCEL
UNDO = BACK SPACE
TIME LEFT: 03:43:46 (8) SPEED: 0.000X
Adjust Prompt
With the Adjust Prompt active, the following keys in the Jog Section change from transport controls
to adjustment controls:
• << (Rewind) changes to ADJ-, which allows you to nudge a value down by one increment.
• >> (Fast-forward) changes to ADJ+, which allows you to nudge a value up by one
increment.
• EDIT IN changes to , which allows you to move the Time Code Register’s underline to
the left.
• EDIT OUT changes to , which allows you to move the Time Code Register’s underline
to the right.
• The Jog Wheel changes to allow you to dial in values.
Press ADJUST again to return the buttons to transport functions.
Capturing Locate Values
When the CAPTURE button is pressed, the current position as shown on the Time Code Display is
copied into the LOC Register. It can now be stored away, and used to reposition to this spot later.
You can capture positions whether the transport is running or not.
Storing and Recalling Locate Values
Press STORE to access the Store Locate Point Prompt, which allows you to store the value that
currently appears in the LOC Register to one of 100 general purpose locate points in the open file, or
to a special locate point such as the head point, edit in-point, edit out-point, etc.