Manual

3B Scientific GmbH ▪ Rudorffweg 8 ▪ 21031 Hamburg ▪ Germany ▪ www.3bscientific.com
Subject to technical amendments
© Copyright 2012 3B Scientific GmbH
• Start the programme „CNT“ in the folder
„CNT“, and select the ComPort from the File
pull down menu, used to connect to the
Counter
When the counter has been correctly connected
with the supplied cable, the programme auto-
matically displays the current function set on the
counter. See the example below.
• To change language, use this sub-menu
<File>, <Instrument Setup>, <Language>:
In the pull-down menu “File” the following is
available:
ComPort: Selection of the PC‘s Serial port
(COM-1 or COM-2).
U21005 setup Data flow: Selection of
Start/Stop or Continuous data fl ow from the
counter to the PC. Only active during IMPULSE
COUNT and START A - STOP B.
Language: Select the language.
Programme Information: Displays the version
of the programme etc. If a counter is connected,
the version of the instrument is also displayed.
Exit: Exit programme.
In the menu “Function” all of the above de-
scribed measurement methods are available.
The following keys can be used when IMPULSE
COUNT or IMPULSE COUNT GM were chosen:
Measurement method IMPULSE
COUNT
IMPULSE
COUNT
GM
Impulse count cont. F1 Shift F1
Impulse count 1 s F2 Shift F2
Impulse count 6 s F3 Shift F3
Impulse count 10 s F4 Shift F4
Impulse count 60 s F5 Shift F5
Impulse count 10 s,
5 s pause
F6 Shift F6
Impulse count 10 s
continuous
F7 Shift F7
7. Care and maintenance
• Before cleaning the counter, disconnect it
from the mains.
• Use a soft, damp cloth to clean it.
8. Disposal
• The packaging should be disposed of at
local recycling points.
• Should you need to dispose of the counter
itself, never throw it away in normal domes-
tic waste. Local regulations for the disposal
of electrical equipment will apply.