User's Manual

Modifying Spanning Tree 133
Modifying
Spanning Tree
TheSpanning Tree Modify Page contains information for modifying
Spanning Tree parameters.
Monitor users have no access to this page.
To modify Spanning Tree:
1 Click Device > Spanning Tree > Modify. The Spanning Tree Modify
Page opens:
Figure 71 Spanning Tree Modify Page
The Spanning Tree Modify Page contains the following fields:
■ STP — Indicates if STP is enabled on the port. The possible field values
are:
■ Enable — Indicates that STP is enabled on the port.
■ Disable — Indicates that STP is disabled on the port.
■ Port Fast — Indicates if Fast Link is enabled on the port. If Fast Link
mode is enabled for a port, the Port State is automatically placed in
the Forwarding state when the port link is up. Fast Link optimizes the
STP protocol convergence. STP convergence takes 30 seconds and is
not dependent on the number of switches in the network. The
possible field values are: