User Manual

86 APPENDIX B: INSTALLING THE DYNAMICAccess LAN AGENT
Installing the DynamicAccess LAN Agent
To install the DynamicAccess LAN agent:
1 Make sure that the NIC and the network driver are
installed on your PC.
See “Verifying Successful Installation” in Chapter 3 to
confirm that the NIC is properly installed in the PC.
2 Start Windows.
3 Insert the EtherCD in the CD-ROM drive.
The EtherCD Welcome screen appears.
If the EtherCD Welcome screen does not appear, enter
the following command from Run option of the
Windows Start menu:
d:\installs\setup.exe
where d:\ represents the letter name of the CD-ROM drive.
4 Click NIC Software.
5 Click DynamicAccess Technologies.
6 Click DynamicAccess LAN Agent.
Operating
System
PC Requirements
Recommended
Microsoft Service Pack
Windows 95 486/75 MHz CPU
16 MB RAM (32 MB recommended)
5 MB available hard drive space
Windows 95 OSR2 or
Service Pack 1
Windows 98 486/75 MHz CPU
16 MB RAM (32 MB recommended)
5 MB available hard drive space
None
Windows NT 4.0 Pentium/100 MHz CPU
32 MB RAM
5 MB available hard drive space
Service Pack 3
Windows NT 3.51 Pentium/100 MHz CPU
32 MB RAM
5 MB available hard drive space
Service Pack 5
book Page 86 Thursday, July 29, 1999 12:23 PM