User Manual

27
4
Installing the
NetWare Server Driver
This chapter describes how to install the NetWare 3.x, 4.x, and 5.x server drivers. To obtain
the latest shipping version of a driver, go to:
http://www.3com.com/
Installing the Server Driver
The \NWSERVER directory on the EtherCD contains the network driver file (3C90XC.LAN)
to be used for servers running NetWare 3.x, 4.x or 5.x.
Additional files (NetWare Loadable Modules [NLMs]) that are required for servers running
NetWare are on the EtherCD in the \NWSERVER directory, or they can be obtained from Novell.
Obtaining NetWare Loadable Modules
You can obtain current NLMs for the NetWare servers listed in the table below from the
Novell World Wide Web site:
http://www.support.novell.com
NetWare 3.12
To install the driver in a NetWare 3.12 server:
1 Copy the MSM31X.NLM, ETHERTSM.NLM, and NBI31.NLM files from the EtherCD to
the directory on your hard drive where other NLM files are located.
2 Copy the LAN driver file (3C90XC.LAN) from the EtherCD to the same directory.
3 Add the following two lines to the AUTOEXEC.NCF file:
load C:\NWSERVER\3C90XC.LAN slot=<slot> NAME=<name>
FRAME=<frametype>
bind ipx to <name> net=<number>
4 Save and exit the file, and then reboot the server.
NOTE: The 3Com PCI NICs do not support NetWare 3.xx or 4.xx servers that are
not updated to the latest driver pack.
Netware Server NLM Name
NetWare 3.12 ETHERTSM.NLM
NBI31X.NLM
MSM31X.NLM
NetWare 4.10, 4.11 ETHERTSM.NLM
NBI.NLM
MSM.NLM
NetWare 5.x ETHERTSM.NLM
MSM.NLM