Owner's Manual

2
IMA-E1/T1 INTERFACE
CONFIGURATION COMMANDS
cable
Syntax cable { long | short }
undo cable
View ATM E1/T1 interface view
Parameter long: Long haul mode, with a cable length in the range 151 to 500 m (495 to
1640 ft.).
short: Short haul mode, with a cable length in the range 0 to 150 m (0 to 495 ft.).
Description Use the
cable command to set the cable length of the ATM E1 interface.
Use the
undo cable command to restore the default.
By default, long haul mode applies, allowing of cable length mode adaptation. In
this case, the long haul mode is adopted first. If the cable is of short haul mode,
the system switches to the short haul mode automatically.
To have the system use the short haul mode, use the cable short command.
Related command: frame-format.
Example # Set the cable length of ATM E1 interface 5/0 to long haul.
<Sysname> system-view
[Sysname] interface atm 5/0
[Sysname-Atm5/0] cable long
clock
Syntax clock { master | slave }
undo clock
View ATM E1/T1 interface view
Parameter master: Sets the clock mode as master.