Owner's Manual

154 CHAPTER 7: POS INTERFACE CONFIGURATION COMMANDS
display ip interface pos
Syntax display ip interface pos interface-number
View Any view
Parameter interface-number: Interface number.
Description Use the
display ip interface pos command to view the IP-related configuration
and status information of the specified POS interface.
Example # Display IP-related status and configuration information about the interface POS
1/0.
<Sysname> display ip interface pos 1/0
Pos1/0 current state :UP
Line protocol current state :UP
Internet Address is 13.13.13.13/8 Primary
Broadcast address : 13.255.255.255
The Maximum Transmit Unit : 1500 bytes
ip fast-forwarding incoming packets state is Enabled
ip fast-forwarding outgoing packets state is Enabled
input packets : 5, bytes : 420, multicasts : 0
output packets : 5, bytes : 420, multicasts : 0
TTL invalid packet number: 0
ICMP packet input number: 5
Echo reply: 5
Unreachable: 0
Source quench: 0
Routing redirect: 0
Echo request: 0
Router advert: 0
Router solicit: 0
Time exceed: 0
IP header bad: 0
Timestamp request: 0
Timestamp reply: 0
Information request: 0
Information reply: 0
Netmask request: 0
Netmask reply: 0
Unknown type: 0
display ipv6 interface pos
Syntax display ipv6 interface pos interface-number
View Any view
Parameter interface-number: Interface number.