Owner's Manual

1632 CHAPTER 96: MPLS TE CONFIGURATION COMMANDS
View Tunnel interface view
Parameter times: Number of tunnel setup retries, in the range 1 to 4294967295.
Description Use the
mpls te retry command to configure the maximum number of tunnel
setup retries.
Use the
undo mpls te retry command to restore the default.
The default maximum number of tunnel setup retries is 5.
You may configure the system to attempt setting up a tunnel multiple times until it
is established successfully or until the number of attempts reaches the upper limit.
Related command: mpls te timer retry.
Example # Set the maximum number of tunnel setup retries to 10.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te retry 10
mpls te route-pinning
Syntax mpls te route-pinning
undo mpls te route-pinning
View Tunnel interface view
Parameter None
Description Use the
mpls te route-pinning command to enable route pinning.
Use the undo mpls te route-pinning command to restore the default.
By default, route pinning is disabled.
n
The mpls te route-pinning command cannot be used together with the mpls te
reoptimization command and the mpls te auto-bandwidth adjustment
command.
Example # Enable route pinning.
<Sysname> system-view
[Sysname] interface tunnel 0
[Sysname-Tunnel0] mpls te route-pinning