Owner's Manual

2574 CHAPTER 173: VOIP CONFIGURATION COMMANDS
Use the undo delay wink-rising command to restore the default.
By default, the maximum amount of time the originating side waits for a wink
signal after sending a seizure signal is 3,000 milliseconds in the wink start mode.
Related command: em-signal.
Example # Set the maximum amount of time the originating side waits for a wink signal
after sending a seizure signal in the wink start mode to 2,000 milliseconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] em-signal wink
[Sysname-voice-line1/0] delay wink-rising 2000
delay start-dial
Syntax delay start-dial seconds
undo delay start-dial
View FXS/FXO voice subscriber line view
Parameter seconds: Dial delay in seconds, in the range of 0 to 10.
Description Use the
delay start-dial command to configure the dial delay.
Use the
undo delay start-dial command to restore the default.
By default, the dial delay is 1 second.
Example # Set the dial delay on FXS subscriber line 1/0 to 5 seconds.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] subscriber-line 1/0
[Sysname-voice-line1/0] delay start-dial 5
description (voice entity view)
Syntax description text
undo description
View POTS/VoIP/VoFR entity view
Parameter text: Voice entity description string, consisting of up to 80 characters.
Description Use the
description command to configure a voice entity description string.