Owner's Manual

179
VOFR CONFIGURATION COMMANDS
address
Syntax address { vofr-dynamic serial interface-number dlci-number | vofr-static serial
interface-number dlci-number cid-number }
undo address { vofr-dynamic | vofr-static }
View VoFR entity view
Parameter vofr-dynamic: Specifies a VoFR entity to adopt the dynamic call mode.
vofr-static: Specifies a VoFR entity to adopt the FRF.11 trunk mode.
serial interface-number: Specifies the destination interface of a VoFR entity.
dlci-number: Destination virtual circuit number of a VoFR entity, in the range of 16
to 1007.
cid-number: Destination FRF.11 sub-channel number of a VoFR entity, in the range
of 4 to 255.
Description Use the
address command to configure a channel to the peer voice gateway.
Use the
undo address command to remove the configuration.
By default, no channel to the peer voice gateway is configured.
Note that:
■ The FRF.11 sub-channel number to be configured must be available. That is, the
FRF.11 sub-channel is not occupied.
■ A voice channel will be established for the VoFR entity immediately you execute
the address vofr-static command. The voice channel will be removed after
you execute the undo form of the command or delete the VoFR entity.
Related command: call-mode, vofr, trunk-id, and display fr vofr-info.
Example # Specify DLCI 100 to adopt the dynamic call mode.
<Sysname> system-view
[Sysname] voice-setup
[Sysname-voice] dial-program