Owner's Manual

402 CHAPTER 22: FRAME RELAY CONFIGURATION COMMANDS
Use the undo mfr bundle-name command to restore the default.
By default, BID is represented by mfr plus frame relay bundle number, for example,
mfr4.
Each MFR bundle has a BID, which only has local significance. Therefore, the same
BID can be used at both ends of the link.
Note that:
■ In spite of the default BID, you cannot configure a BID as a string in the form of
mfr + number.
■ After changing the BID of an MFR interface, you must execute the shutdown
and undo shutdown command on the interface to validate the new BID.
Example # Set the frame relay link MFR4 BID to bundle1.
<Sysname> system-view
[Sysname] interface mfr 4
[Sysname-MFR4] mfr bundle-name bundle1
mfr fragment
Syntax mfr fragment
undo mfr fragment
View MFR interface view
Parameter None
Description Use the
mfr fragment command to enable fragmentation on the MFR bundle.
Use the
undo mfr fragment command to disable the function.
By default, fragmentation is disabled on the MFR bundle.
Example # Enable fragmentation on interface MFR 4.
<Sysname> system-view
[Sysname] interface mfr 4
[Sysname-MFR4] mfr fragment
mfr fragment-size
Syntax mfr fragment-size bytes
undo mfr fragment-size
View Frame relay interface view and MFR interface view