Owner's Manual

562 CHAPTER 36: BRIDGING CONFIGURATION COMMANDS
Example # Clear the traffic statistics information about bridge set 1.
<Sysname> reset bridge traffic bridge-set 1
x25 map bridge
Syntax x25 map bridge x121-address x.121-address broadcast
undo x25 map bridge x121-address x.121-address
View Interface view
Parameters x121-address x.121-address: X.121 address of the peer host.
broadcast: Enables bridging of broadcasts to the X.25 destination.
Description Use the
x25 map bridge command to create an X.25-to-bridging mapping.
Use the undo x25 map bridge command to remove an X25-to-bridging
mapping.
By default, no X.25-to-bridging mappings exist.
Related command: display x25 map on page 426.
Example # Create an X.25-to-bridging mapping on Serial2/0.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] link-protocol x25
[Sysname-Serial1/0] x25 x121-address 100
[Sysname-Serial1/0] x25 map bridge x121-address 20112451 broadcast
[Sysname-Serial1/0] bridge-set 1