Owner's Manual

654 CHAPTER 42: PORT ISOLATION CONFIGURATION COMMANDS
Description Use the port-isolate enable command to add the current port to the default
isolation group (Group 1) as an ordinary port.
Use the
undo port-isolate enable command to remove the port from the
isolation group.
Configured in Ethernet interface view, the setting is effective on the current port
only; configured in port group view, the setting is effective on all ports in the port
group.
Refer to “Link Aggregation Configuration Commands” on page 473 for
information about port groups.
This command adds a port to the default isolation group 1.
Example # Add port Ethernet 1/0 to isolation group 1.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] port-isolate enable