- 3com Network Interface Card User Guide

118 CHAPTER 6: CONFIGURING THE NIC
3 Click 3Com NIC Doctor.
The 3Com NIC Diagnostics General screen appears.
4 If your PC has more than one NIC installed, open the
Network Interface Card (NIC) list box and select the
NIC to be configured.
5 Click the Configuration tab.
The Configuration screen appears.
6 Under Network Parameter, select the setting to
be changed.
For a description of each setting, click the question mark (?)
in the upper right corner of the screen, move it over a
setting, and click once.
7 Open the Set Value list box and select a new value
from the list of available options.
Repeat the process to change any other configuration
setting.
To undo changes and return the settings to their previous
values, click Undo Changes.
To return the settings to the factory default settings, click
Set Factory Defaults.
8 Click OK to save the changes and exit the program.
Using the 3Com DOS Configuration Program
This section describes NIC configuration for computers
running DOS or NetWare.
Click Help to obtain general information about the
function of a screen. To obtain specific information about
any topic on a screen, click the question mark (?) in the
upper right corner of the screen, move it over a topic, and
click once.
For complete instructions on using the 3Com NIC
Diagnostics program, see Running NIC Diagnostics on
page 143.