User manual

System Issues 13
Error Message for Unsupported Configurations
During system power on, Intelligent Switching software version 8.1.1 or
later can detect the unsupported configurations that are outlined in
Table 2. If the system detects an unsupported configuration, it does not
boot up normally and initiates a critical error condition, as indicated by
these symptoms:
■ All LEDs on the system light.
■ The Config LED flashes to indicate the critical error.
■ The following error message appears:
FATAL Error .....
Option Module Configuration Not Supported.
Illegal Combination of Adapter Cards
SYSTEM HALTED!
A similar error message appears if a newer Ethernet 10BASE-FL module
(3C201400A) is present but is not functioning properly:
An Overcurrent Condition Has Occurred For The
Adapter Card In Slot - 3 or 4
Please Remove This Adapter Card and Contact 3Com
Technical Support.
SYSTEM HALTED!