User manual
Table Of Contents
- Introduction
- Installing the Outdoor Bridge
- Configuring the Building-to-Building Bridge
- Using the 3Com Wireless Device Manager
- Saving Configuration Changes
- Changing System Properties
- Setting IP Network Properties
- Setting up Protocol and Port Filtering
- Setting Wireless Network Properties
- Setting Advanced Performance Properties
- Setting up an Ad Hoc Network
- Optimizing an Ad Hoc Installation
- Setting up an Access Point Infrastructure Network
- Changing Security Settings
- Resetting the Bridge
- Restoring a Bridge to Factory Defaults
- Upgrading the System
- Changing the Administration Password
- Backing up a Configuration
- Restoring a Configuration
- Viewing the Client List
- Viewing Connection Status
- Viewing the System Summary
- Interoperating with Third-Party Equipment
- Troubleshooting
- Technical Support
- Regulatory Compliance Information
- Index
14
MOUNTING THE BRIDGE TO A MAST
The bridge can be placed in any suitable outdoor location (see “Installation
Guidelines” on page 11). Refer to the adjustable mount instruction sheet that
comes with the bridge mounting hardware, and the illustrations below:
Make sure that all bridges
are properly oriented for
polarization as described
in “Polarization” on
page 12. Use the
polarization indicators on
the antenna panel to
guide orientation. VERT
POL indicates vertical
polarization and HORIZ
POL indicates horizontal
polarization.