Datasheet

PT-100 Test

Calibration Instrument

Measuring and simulation of resistance

or temperatures can be

done simultaneously.

Temperature or resistance are presented

on a LCD-display, both for the simulated

and measured signals.

High accuracy and resolution.

Easy to use.

Range from -40 to 500 °C

Net adaptable with special transformer .

Compact design: 95 x 159 x 33 mm.

Weight 400g

PT-100 Test measures and simulates resistance from

PT-100 transmitters. It is equipped with connectors

for both two- and three-wire transmitters.

The result is presented on a LCD-display,

in Ohms or in Centigrade.

480Range from -40 to +480°C

PAGE 1
PT-100 Test Calibration Instrument PT-100 Test measures and simulates resistance from PT-100 transmitters. It is equipped with connectors for both two- and three-wire transmitters. The result is presented on a LCD-display, in Ohms or in Centigrade. Measuring and simulation of resistance or temperatures can be done simultaneously. Temperature or resistance are presented on a LCD-display, both for the simulated and measured signals. High accuracy and resolution. Easy to use.
PAGE 2
Technical Data Output signal To read the output signal value on the display, switch the ”DSPL”-button to the ”OUT” position, then switch the ”SIM”-button to the ”DSPL” position. Now you can read the wanted temerature (°C) or resistance (Ω). To begin simulation after the signal had been adjusted, switch the ”SIM”-button to the ”OUT” position.